When CNC vertical lathe manufacturers deal with CNC vertical lathe tailstock faults, they may adopt different solutions based on the specific fault type. The following are some common CNC vertical lathe tailstock failures and their possible solutions:

1. The tailstock of CNC vertical lathe cannot support the workpiece:

CNC vertical lathe Check whether the spring or locking device inside the tailstock is faulty and adjust or replace it.

The CNC vertical lathe resets the height of the tailstock so that it can support the workpiece.

2. The tailstock width of the CNC vertical lathe is not enough:

Consider using an indexing head for CNC vertical lathe processing to ensure processing accuracy.

3. The tailstock of the CNC vertical lathe is loose:

Use the CNC vertical lathe to check whether the loose part is a loose lock nut, and try to adjust it with a wrench.

If the problem persists, consider replacing the locking device or improving the way the tailstock is secured.

The disc spring inside the tailstock of a CNC vertical lathe is broken or slowly recovers from deformation:

Disassemble the tailstock and replace the internal disc spring.

Adjust the pressure of the CNC vertical lathe system to ensure that the tailstock does not move backward after being tightened.

4. Improve the equipment site environment:

CNC vertical lathes reduce the chance of external fine particles entering the hydraulic system.

CNC vertical lathes reduce the temperature of the on-site environment, such as building a transparent tempered glass sealed room and installing air conditioners to cool down the hydraulic station and instrument control panel.

In addition, for other common faults, such as the phenomenon of taper and big head in the workpiece, it may be caused by the machine tool placement level not being adjusted properly, the material being too hard when turning the long axis or the tool cutting too deep, the tailstock thimble and the spindle being not concentric, etc. . CNC vertical lathe solutions include using a level to adjust the level of the machine tool, choosing a reasonable process and cutting feed, adjusting the tailstock, and ensuring that the tool is sharp.

To sum up, when CNC vertical lathe manufacturers deal with tailstock failures of CNC vertical lathes, they need to conduct detailed inspections and diagnoses based on the specific circumstances, and then take corresponding measures to repair and adjust. At the same time, manufacturers should also pay attention to the daily maintenance and upkeep of equipment to prevent failures.