The small CNC vertical lathe is a high-end mechanical equipment. Correct operating steps need to be followed when using it to reduce potential safety risks and ensure the stable operation and service life of the equipment. Next, we will introduce the correct operating steps for small CNC vertical lathes.

1. Preparation
Before using a small CNC vertical lathe, preparation work needs to be done first. First, the surface of the machine tool should be cleaned to ensure that it is free of debris and dirt. Secondly, the lubrication of maintenance parts on the equipment needs to be checked to ensure that it can work properly.

2. Set up the tool
Before setting the tool, you need to turn on the power of the machine tool and check and set various parameters at the same time. Then, first set the number and type of the tool in the CNC system. Next, insert the cutter into the card slot and secure it properly on the card slot. Finally, calibration and adjustments are made to ensure the tool is in the correct position and angle.

3. Adjust the workbench
Before adjusting the height and angle of the workbench, you should first check the cleanliness of the workbench surface to ensure that it is free of dirt and debris. Then, adjust the height and angle of the workbench to suit the processing needs. After the adjustment is completed, it should be inspected to ensure that it meets the requirements.

4. Processing program settings
Before setting up the processing program, the workbench and cutting area should be cleaned first. Then, set the processing program and corresponding parameters in the CNC system to meet the processing requirements. After the setting is completed, the corresponding processing program should be detected and saved.

5. Start processing
Before starting processing, you should first check whether the processing procedures and equipment meet the requirements. Then, start the machine and let the table begin to move. During the work process, you should pay attention to observe the working status and adjust the processing parameters at any time to ensure the processing effect and work safety.

6. End of processing
After processing, the power of the machine tool should be turned off first, and the tool and worktable should be returned to their original positions. Then, clear the workbench and cutting area to keep the equipment tidy. Finally, save the processing program and corresponding data for next processing use.

The above are the correct operating steps for small CNC vertical lathes. I hope it will be helpful to everyone. When using machine tools, you must follow operating procedures to ensure the safety and normal operation of the equipment to improve processing efficiency and quality.